Jeep Liberty: Elapsed Time
Shows the total elapsed time of travel since the last reset.
Elapsed time will increment when the ignition switch is in the RUN or START position.
Elapsed time is displayed as follows:
hours:minutes:seconds
Elapsed time can be reset by pressing and holding the SELECT button (as prompted in the EVIC display). Upon reset all digits will change to zeros and time will start incrementing again if the ignition switch is in RUN or START.
Tire Psi
Press and release the MENU button until Tire PSI is displayed. Tire pressure information is displayed as follows: • If tire pressure is OK for all tires, TIRE and a vehicle graphic are display ...EVIC Units Selection (Units In Display)
Displays the units used for the Outside Temperature, Average Fuel Economy, Distance to Empty and Tire Pressure features. Press and release the SELECT button to toggle units between U.S. and METR ...See also:
Breaking-in of new brake pads and linings
When replacing the brake pad or lining,
use only genuine SUBARU parts. After
replacement, the new parts must be
broken in as follows. ...
Driving after a collision
If the vehicle has been involved in a collision,
the text Safety mode See manual may
appear in the information display. This indicates
that the vehicle's functionality has been
reduced.
NOTE
...
Qualified specialist workshop
An authorized Mercedes-Benz Center is a qualified specialist workshop. It has
the necessary specialist knowledge, tools and qualifications to correctly carry
out the work required on your vehicle. ...