Jeep Liberty: Disabling And Enabling HSA
This feature can be turned on or turned off. To change the current setting, proceed as follows:
For vehicles equipped with the Electronic Vehicle Information Center (EVIC), refer to “Hill Start Assist,” under Personal Settings (Customer Programmable Features),” under “Electronic Vehicle Information Center (EVIC)” in “Understanding Your Instrument Panel” for further information.
For vehicles not equipped with the EVIC, perform the following steps:
NOTE: You must complete Steps 1 through 8 within 90 seconds.
1. Center the steering wheel (front wheels pointing straight forward).
2. Shift the transmission into PARK 3. Apply the parking brake.
4. Start the engine.
5. Rotate the steering wheel one-half turn to the left.
6. Press the “ESC Off” button located in the lower switch bank below the climate control four times within twenty seconds. The “ESC Off Indicator Light” should turn on and turn off two times.
7. Rotate the steering wheel back to center and then an additional one-half turn to the right.
8. Turn the ignition switch to the OFF position and then back to the ON position. If the sequence was completed properly, the “ESC Off Indicator Light” will blink several times to confirm HSA is disabled.
9. Repeat these steps if you want to return this feature to its previous setting.
Towing With HSA
HSA will provide assistance during acceleration on an incline while towing a trailer. WARNING! • If you use a trailer brake controller with your trailer, the trailer brakes may be activated a ...Hill Descent Control (HDC) – If Equipped
HDC is only intended for low speed off-road driving. HDC maintains vehicle speed while descending hills in off-road driving conditions by applying the brakes when necessary. When enabled, HDC se ...See also:
Settings
Settings for Lane Departure Warning can be
made in the menu system by pressing My
Car. Go to Settings
Car settings
Driver
support systems
Lane Departure
Warning.
There are two alt ...
Emergency starting
Jump starting Jump starting can be dangerous if done incorrectly. Therefore,
to avoid harm to yourself or damage to your vehicle or battery, follow the jump
starting procedures listed on page 6-6. ...
Operating the HomeLink® Universal Transceiver
HomeLink Universal Transceiver (once programmed)
may now be used to activate the
garage door, etc. To operate, simply push the
appropriate programmed HomeLink® Universal
Transceiver button. T ...