Subaru Forester: Daytime running light system (if equipped)
The brightness of the illumination of the high beam headlights is reduced by the daytime running light system.
The light switch must always be turned to the “” position when it is dark outside.
The high beam headlights will automatically
illuminate at reduced brightness
when the engine has started, under the
following conditions:
- The select lever is in a position other
than the “P” position (AT models).
- The parking brake is fully released.
- The light switch is in the “OFF” or “” position.
NOTE
When the light switch is in the “”
position, the front side marker lights,
tail lights and license plate lights are
also illuminated.
Headlight flasher
Headlight flasher To flash the headlights, pull the lever toward you and then release it. The high beam will remain on for as long as you hold the lever. The headlight flasher works even ...Automatic headlight beam leveler (models with HID headlights)
The HID headlights generate more light than conventional halogen headlights. Therefore a driver of an oncoming vehicle may experience too much glare when your headlight beam height adjustment ...See also:
Manual transmission operation (if equipped)
Using the clutch
Manual transmission vehicles have a starter interlock that prevents
cranking the engine unless the clutch pedal is fully pressed.
To start the vehicle:
1. Make sure the parkin ...
Weight of the vehicle
This section will guide you in the proper loading of your vehicle and/or trailer,
to keep your loaded vehicle weight within its design rating capability, with or
without a trailer. Properly loadin ...
Additional remote controls
A maximum of three controls can be
programmed to each vehicle. Contact your
Land Rover dealer to purchase additional units
and have them programmed to your vehicle. ...