Range Rover Evoque: Daytime running lamps

Daytime running lamps are LED lamps.

With the lighting control in the OFF position or in AUTO position while lighting conditions do not require headlamps on, then daytime running lamps will switch on automatically under the following conditions: - The engine is running.

- The gear selector is out of park (automatic transmission).

- The parking brake is not applied - market dependent.

Unless required or prohibited by law,

Unless required or prohibited by law, daytime running lamps can be disabled or enabled by your Dealer/Authorised Repairer.

READ NEXT:

 Headlamp courtesy delay

This feature operates whenever the lamps master switch is in the AUTO (5) position and the ignition is turned off. The headlamps will remain illuminated for up to 240 seconds. Note: The time delay

 High beam assist

This feature of the Xenon lighting automatically selects and deselects high beam, under specific conditions of road lighting and in the absence of other vehicle’s lights. The system is only acti

 Auto lamps windscreen wiper detection

If Auto lamps is selected and the windscreen wipers are switched on for 20 seconds or more, the side lamps, tail lamps and headlamps will switch on automatically. When the wipers are switched off,

SEE MORE:

 Fuel Tank and Lines - Component Location

Component Location COMPONENT LOCATION - ROW Connection to purge valve Fuel Low Pressure (LP) sensor Fuel fired booster heater - fuel supply pipe connection (if fitted) LP fuel supply pipe Fuel fired booster heater - fuel supply pipe (if fitted) Fuel pump delivery module Fuel tank breather p

 Front End Body Panels

Torque Specifications Fender Removal NOTE: Removal steps in this procedure may contain installation details. 1. Refer to: Front Bumper Cover (501-19 Bumpers, Removal and Installation). 2. WARNING: Make sure to support the vehicle with axle stands. Raise and support the vehicle. 3. 4. 5. 6. Torqu

© 2011-2024 Copyright www.rrevoque.org