Range Rover Evoque: Conditions preventing automatic engine stop
The engine will not automatically stop if:<>
- the external temperature is below approximately 0°C (32°F)
- the external temperature is above approximately40°C (104°F)
- engine has not reached operating temperature
- driver’s seat belt is not fastened
- driver’s door is not fully closed
- the driver’s foot is on either the clutch or accelerator pedals
- climate control system demand is high
- battery charge is low
- the DPF is regenerating
- HDC or a Terrain Response special program are selected
Note: The stop/start system is disabled when a
trailer electrical connection is made.
READ NEXT:
The engine will automatically start if:<>
- climate control system demand increases
- the vehicle’s speed reaches approximately 4km/h (2.5mph)
- HDC or a Terrain Response special program ar
Disabling stop/start
To switch the system off (preventing automatic
stop/start) press the ECO switch. The LED
indicator will extinguish to confirm that the
system is off.
Note: The engine will
In the event that the engine stalls, it can be
restarted by fully depressing the clutch pedal.
Note: Automatic stall restart will only operate
once. If the engine is stalled a second time the
engi
SEE MORE:
Removal
NOTES:
The B-Pillar reinforcement is manufactured from boron steel.
The B-Pillar reinforcement is unpicked from the side panel reinforcement,
'ring-frame', it is not serviced separately.
There are 2 NVH components serviced on the new B-Pillar reinforcement.
1. The B-Pillar reinforcement i
Removal
NOTES:
It is necessary to remove the inner quarter panel to enable removal and
installation of the rear wheelhouse outer.
The rear wheelhouse outer is manufactured from mild steel.
This method describes the LH rear wheelhouse outer, the RH side is similar.
1. The rear wheelhouse outer is
© 2011-2024 Copyright www.rrevoque.org