Subaru Forester: Checking the fluid level - Brake fluid - Maintenance and service - Subaru Forester Owner's ManualSubaru Forester: Checking the fluid level

Checking the fluid level
Checking the fluid level

1) “MAX” level mark
2) “MIN” level mark

Check the fluid level monthly.

Check the fluid level on the outside of the reservoir. If the level is below “MIN”, add the recommended brake fluid to “MAX”.

Use only brake fluid from a sealed container.

- Never let brake fluid contact your

- Never let brake fluid contact your eyes because brake fluid can be harmful to your eyes. If brake fluid gets in your eyes, immediately flush them thoroughly with clean water. For safety, when performing this work, wearing eye protection is advisable.

- Brake fluid absorbs moisture from the air. Any absorbed moisture can cause a dangerous loss of braking performance.

- If the vehicle requires frequent refilling, there may be a leak. If you suspect a problem, have the vehicle checked at your SUBARU dealer.

- When adding brake fluid, be careful

- When adding brake fluid, be careful not to allow any dirt into the reservoir.

- Never splash the brake fluid over painted surfaces or rubber parts.

Alcohol contained in the brake fluid may damage them.

- Be careful not to spill brake fluid when adding it. If brake fluid touches the exhaust pipe, it may cause a bad smell, smoke, and/or a fire. If brake fluid gets on the exhaust pipe, be sure to wipe it off.

    Recommended brake fluid
    Refer to “Fluids”. Never use different brands of brake fluid together. Also, avoid mixing DOT 3 and DOT 4 brake fluids even if they are the same brand. ...

    See also:

    Driving tips
    Observe the notes on ESP® trailer stabilization (). The maximum permissible speed for vehicle/ trailer combinations depends on the type of trailer. Before beginning the journey, check the trail ...

    When checking or servicing in the engine compartment (non-turbo models)
    - Do not contact the belt cover while checking the components in the engine compartment. Doing so may cause your hand to slip off the belt cover and result in an unexpected injury. - D ...

    Starting the engine
    1 Shift the shift lever to P and apply the brakes. Touch the Toyota emblem side of the electronic key to the “ENGINE START STOP” switch. If any of the doors is opened and closed while the k ...