Range Rover Evoque: Automatic switch off
Land Rover Range Rover Evoque L538 (2011–2018) Owner's Manual / Cruise control / Automatic switch off
Cruise control will switch off but the set speed will remain in the memory when: - The CAN button (3) is pressed.
- The brake pedal is pressed.
- Speed falls below 30km/h (18mph).
- Neutral, Park or Reverse gear is selected on vehicles with automatic transmission.
- Dynamic Stability Control is operating.
- The difference between the actual and set speed is too great.
- The vehicle reaches a speed of 170km/h (105.6mph).
- The accelerator pedal is used to accelerate beyond the set speed for too long a period.
Cruise control will switch off and clear the memory when: - The ignition system is switched off.
- A fault occurs. The cruise control system will switch off and cannot be used until the fault is cleared.
READ NEXT:
Cruise eco data
Diesel only
When enabled, a CO2 emission indicator is
displayed in the message centre. The higher
the numeric reading, the more CO2 is being
emitted and the more fuel is being used. See
56, VEH
Dynamic stability control (DSC)
DSC is automatically enabled each time the
engine is started, and is automatically enabled
by some of the Terrain response special
programs.
The vehicle is not designed
for
cornering at the sa
SEE MORE:
Audio
Front Control Module (ACM) - Low Line
Audio Front Control Module - Low Line (ACM)
CAUTION:
Diagnosis by substitution from a donor vehicle is NOT acceptable. Substitution
of control modules does
not guarantee confirmation of a fault, and may also cause additional faults in
the vehicle being tested and/or the donor
vehicle.
Transmission Draining and Filling
WARNING: Observe due care when draining, as the fluid can be very hot.
1. WARNING: Make sure to support the vehicle with axle stands.
NOTE: Make sure that the vehicle is standing on a level
surface.
Raise and support the vehicle.
2. Refer to: Engine Undershield (501-02 Front End Body Panels,
Remo
© 2011-2024 Copyright www.rrevoque.org
