Jeep Liberty: To Enter Remote Start Mode - How To Use Remote Start - Remote Starting System — If Equipped - Things To Know Before Starting Your Vehicle - Jeep Liberty Owner's ManualJeep Liberty: To Enter Remote Start Mode

Press and release the REMOTE START button

Press and release the REMOTE START button on the RKE transmitter twice within five seconds.

The parking lights will flash and the horn will chirp twice (if programmed). Then, the engine will start and the vehicle will remain in the Remote Start mode for a 15-minute cycle.

NOTE:
• If your power door locks were unlocked, Remote Start will automatically lock the doors.

• If an engine fault is present or fuel level is low, the vehicle will start and then shut down in 10 seconds.

• For security, power window operation and sunroof or Sky Slider operation (if equipped) is disabled when the vehicle is in the Remote Start mode.

• The engine can be started two consecutive times (two 15-minute cycles) with the RKE transmitter. However, the ignition switch must be cycled to the ON/RUN position before you can repeat the start sequence for a third cycle.

    Remote Start Abort Message On Electronic Vehicle Information Center (EVIC) — If Equipped
    The following messages will display in the EVIC if the vehicle fails to remote start or exits remote start prematurely: • Remote Start Aborted — Door Ajar • Remote Start Aborted — Hood A ...

    To Exit Remote Start Mode Without Driving The Vehicle
    Press and release the REMOTE START button one time or allow the engine to run for the entire 15-minute cycle. NOTE: To avoid unintentional shut downs, the system will disable the one-time press o ...

    See also:

    Measuring techniques
    Your best source of information about actual fuel economy is you, the driver. You must gather information as accurately and consistently as possible. Fuel expense, frequency of fill-ups or fuel gaug ...

    Activating the rear view camera
    Make sure that the SmartKey is in position 2 in the ignition lock. Make sure that the "rear view camera" function is selected in COMAND (see the separate operating instructions for C ...

    Tire and Loading Information Label
    Label Example A vehicle specific Tire and Loading Information label is attached to the vehicle's center pillar (B-pillar). With the driver's door open, you will find the label attached ...