Range Rover Evoque: Using traction devices

heavy Only use traction devices in heavy snow conditions, on hard road surfaces.
Dynamic Stability Control (DSC) must be switched off when using traction devices.
Never exceed 50 km/h (30 mph) when traction devices are fitted.
Never fit traction devices to a temporary use spare wheel.

Land Rover approved traction devices may be used to improve traction on a hard road surface in heavy snow conditions. They should not be used in off-road conditions.

If it becomes necessary to fit traction devices, the following points must be observed: - Only Land Rover approved traction devices should be used on the vehicle. Only Land Rover approved traction devices have been tested to ensure that they do not cause damage to the vehicle. Contact your Land Rover Dealer/Authorised Repairer for information.

- The wheels and tyres fitted must conform to the specifications of the original equipment.

- Do not fit traction devices to 18, 19 or 20inch diameter wheels.

- Single sided Spike-spyder traction devices or snow chains can be fitted to only the front wheels of vehicles fitted with 17inch diameter wheels.

- Always read, understand and follow the traction device manufacturer's instructions.

- Avoid tyre/vehicle damage, by removing the traction devices as soon as the conditions allow.

READ NEXT:

 Tpms inflation pressure compensation

If your vehicle is fitted with 18, 19 or 20 inch wheels with TPMS, they can be replaced with 17 inch wheels with TPMS, so enabling the use of snow chains or traction devices. Tyre pressures of veh

 Vehicle recovery

 Recovery

The method for recovery/ transportation of the vehicle is on a transporter or trailer designed for that purpose. Ensure that transportation is carried out by suitably qualified person and that the

SEE MORE:

 Seat belt safety

Care should be taken to avoid contamination of the webbing with polishes, oils and chemicals, and particularly battery acid. Cleaning may safely be carried out using mild soap and water. The belt should be replaced if webbing becomes frayed, contaminated or damaged. It is essential to repl

 Differential Case Vehicles With: M66 6-Speed Manual Transmission AWD

Removal NOTE: Removal steps in this procedure may contain installation details. 1. WARNING: Make sure to support the vehicle with axle stands. Raise and support the vehicle. 2. Remove the LH rear wheel and tire. Refer to: Wheel and Tire (204-04 Wheels and Tires, Removal and Installation). 3. Refer

© 2011-2024 Copyright www.rrevoque.org