Volvo XC60: Using City Safety
NOTE
The City Safetyâ„¢ function is activated automatically
each time the engine has been
switched off and restarted.
On and Off
In certain situations, it may be desirable to switch City Safetyâ„¢ off, such as when driving in close quarters where leaves, branches, etc.
may obscure the hood and windshield.
When the engine is running, City Safetyâ„¢ can be switched off as follows:
Press My Car in the center console control panel and go to Settings Car settings Driver support systems City Safety.
Select Off.
If the engine is switched off, City Safetyâ„¢ will reactivate when the engine is restarted.
WARNING
The laser sensor emits light when the ignition
is in mode II or higher, even if City
Safetyâ„¢ has been switched off.
To switch City Safetyâ„¢ on again:
• Follow the same procedure as for switching City Safety™ off but select ON.
Function
Location of the laser sensor in the windshield City Safetyâ„¢ monitors traffic ahead of you using a laser sensor mounted in the upper section of the windshield. If a collision is imminent, Ci ...Limitations
The sensor used by City Safetyâ„¢ is designed to detect cars and other larger motor vehicles ahead of your vehicle in both daylight and darkness. However, there are certain limitations and the ...See also:
Engine malfunction (amber)
Engine malfunction (amber)
Illuminates briefly when the
ignition is switched on. If the lamp
flashes or illuminates at any other
time, there is a fault with the engine.
Avoid high speeds and se ...
Tilt Steering Column
This feature allows you to tilt the steering column
upward or downward. The tilt control handle is located
below the steering wheel at the end of the steering
column.
Tilt Steering Control Ha ...
Engine Break-In Recommendations
A long break-in period is not required for the engine and
drivetrain (transmission and axle) in your vehicle.
Drive moderately during the first 300 miles (500 km).
After the initial 60 miles (100 ...