Jeep Liberty: Turn Signals - Lights - Understanding The Features Of Your Vehicle - Jeep Liberty Owner's ManualJeep Liberty: Turn Signals

Move the multifunction lever up or down and the arrows on each side of the instrument cluster flash to show proper operation of the front and rear turn signal lights.

Turn Signal Control
Turn Signal Control

NOTE: If either light remains on and does not flash, or there is a very fast flash rate, check for a defective outside light bulb. If an indicator fails to light when the lever is moved, it would suggest that the indicator bulb is defective.

Lane Change Assist

Tap the lever up or down once, without moving beyond the detent, and the turn signal (right or left) will flash three times then automatically turn off.

    Fog Lights — If Equipped
    To activate the front fog lights, turn on the parking lights or the low beam headlights and pull out on the end of the multifunction lever. Front Fog Light Control NOTE: The front fog lights ...

    High/Low Beam Switch
    Push the multifunction lever away from you to switch the headlights to high beam. Pull the multifunction lever toward you, to switch the headlights back to low beam. ...

    See also:

    Battery Saver Feature
    To protect the battery, the interior lights will turn off automatically 10 minutes after the ignition switch is moved to the LOCK position. This will occur if the interior lights were switched o ...

    Tire tread
    WARNING Although the applicable federal motor vehicle safety laws consider a tire to be worn when the tread wear indicators (TWI) become visible at approximately 1/16 in (1.6 mm), we recomme ...

    Automatic Transmission
    The automatic transmission shift lever is located on the console between the seats. P (Park): This position locks the front wheels. Use P (Park) when starting the engine because the vehicle can ...