Range Rover Evoque: Trailer electrical connection
Connect only approved
electrical
circuits, which are in good condition, to
the trailer socket.
The vehicle connector provides a 5 amp output
which must not be exceeded. An accessory
harness kit increasing output to 15 amp is
available from your Land Rover Dealer.
When a trailer electrical connection
is made and the vehicle’s direction
indicators are used, the trailer
warning indicator will flash in time with the
direction indicators.
READ NEXT:
When towing, ensure there is
sufficient
clearance before opening or closing the
tailgate.
The rear parking aids sensors are automatically
disabled when a trailer with an approved
electrical connector is connected.
Note: Trailers fitted with LED lights will not
disable the rear parking
When a trailer is attached, TSA will
automatically detect when a trailer sway is
developing. It will then gradually reduce vehicle
speed by cutting engine power and applying
the brakes to help reg
SEE MORE:
Removal
NOTE: Removal steps in this procedure may contain installation details.
All vehicles
1. Prior to carrying out the step by step procedure below, Steps 2
and 3 must be followed for knowledge on how to correctly install
and care for the seat cover.
2.
3.
4. If required, follow the steps below
Removal
NOTES:
The fender apron lower panel is manufactured from mild steel.
The panel is serviced less its weld studs
This method describes the LH fender apron lower panel, the RH side is similar.
1. The fender apron lower panel is replaced in conjunction with:
Front bumper cover
Front bumper
© 2011-2024 Copyright www.rrevoque.org