Jeep Liberty: Tire Chains
Use only compact chains, or other traction aids that meet SAE type “Class S” specifications. Chains must be the proper size for the vehicle, as recommended by the chain manufacturer. In addition, only install tire chains of the rear tires with P225/75R16 or smaller tires.
CAUTION!
To avoid damage to your vehicle, tires, or chains,
observe the following precautions:
• Do not use tire chains on vehicles equipped with tires other than P225/75R16 or smaller tires. There may not be adequate clearance for the chains and you are risking structural or body damage to your vehicle.
• Because of limited chain clearance between tires and other suspension components, it is important that only chains in good condition are used. Broken chains can cause serious vehicle damage. Stop the vehicle immediately if noise occurs that could suggest chain breakage. Remove the damaged parts of the chain before further use.
• Install chains on the rear wheels as tightly as possible and then retighten after driving about 1⁄2 mile (0.8 km).
• Do not exceed 45 mph (72 km/h).
• Drive cautiously and avoid severe turns and large bumps, especially with a loaded vehicle.
• Use on Rear Wheels only.
• Do not drive for a prolonged period on dry pavement.
• Observe the tire chain manufacturer’s instructions on method of installation, operating speed, and conditions for use. Always use the lower suggested operating speed of the chain manufacturer if different from the speed recommended by the manufacturer.
These cautions apply to all chain traction devices, including link and cable (radial) chains.
Replacement Tires
The tires on your new vehicle provide a balance of many
characteristics. They should be inspected regularly for
wear and correct cold tire inflation pressure. The manufacturer
strongly recommend ...
Tire Rotation Recommendations
The tires on the front and rear of your vehicle operate at
different loads and perform different steering, handling,
and braking functions. For these reasons, they wear at
unequal rates.
These ...
See also:
How it works
Viewing angles for driver and front seat
passenger are such that neither can view the
full display that the other is viewing. However,
there is an optimum viewing angle of 30
degrees where no cros ...
Auxiliary power sockets
Auxiliary power sockets
Only use Land Rover approved
accessories. Using any other
equipment may damage the vehicle's
electrical system and/or cause battery
discharge. If you are in any doubt
...
Connecting an iPod
1. Open the upper glove box.
2. Push the release button to release
the USB adapter cable.
3. Connect your dock connector to
the iPod correctly and securely.
4. Install the dock connector ...
