Toyota RAV4: Switching the door unlock function
It is possible to set which doors the entry function unlocks.
1 Turn the “ENGINE START STOP” switch OFF. 2 When the indicator on the key surface is turned off, push and hold for approximately 5 seconds while pushing on the key.
The setting changes each time an operation is performed, as shown below. (When changing the setting continuously, release the buttons, wait for at least 5 seconds, and repeat step 2.)
Conditions affecting operation
The smart key system uses weak radio waves. In the following situations, the communication between the electronic key and the vehicle may be affected, preventing the smart key system and wireless re ...Battery-saving function
In the following circumstances, the entry function is disabled in order to prevent the vehicle and electronic key batteries from discharging. ●When the entry function has not been used for 2 ...See also:
Programming HomeLink® for Canadian customers
Prior to 1992, D.O.C. regulations required
hand-held transmitters to stop transmitting after
2 seconds. To program your hand-held transmitter
to HomeLink®, continue to push and hold
the HomeL ...
Venting Sunroof — Express
Press and release the Vent button within one-half second
and the sunroof will open to the vent position. This
is called “Express Vent”, and it will occur regardless of
sunroof position. Duri ...
Edit Uconnect™ Phonebook Entries
NOTE:
• Editing names in the phonebook is recommended
when the vehicle is not in motion.
• Automatic downloaded phonebook entries cannot be
deleted or edited.
• Press the button to begi ...