Range Rover Evoque: Steep slopes

If the vehicle is stationary on a steep, slippery slope, it may begin to slide even with the brakes applied. This is because without wheel rotation, the ABS cannot determine vehicle movement.

To counteract this, briefly release the brakes to allow some wheel rotation. Then re-apply the brakes to allow ABS to gain control.

READ NEXT:

 Emergency brake assist (EBA)

If the driver rapidly applies the brakes, EBA automatically boosts the braking force to its maximum, in order to bring the vehicle to a halt as quickly as possible. If the driver applies the brake

 Electronic brake distribution (EBD)

EBD controls the balance of braking forces supplied to the front and rear wheels, in order to maintain maximum braking efficiency. If the vehicle has a light load (only the driver in the vehicle f

 Electric parking brake (EPD)

The parking brake operates on the rear wheels. Therefore, secure parking of the vehicle is dependent on being on a hard and stable surface. Do not rely on the parking brake to operate effectiv

SEE MORE:

 Multifunction Electronic Modules

Torque Specifications Front Door Module (FDM) Removal NOTE: Removal steps in this procedure may contain installation details. 1. Disconnect the battery ground cable. Refer to: Specifications (414-01 Battery, Mounting and Cables, Specifications). 2. Refer to: Front Door Trim Panel (501-05 Interior

 Front Stabilizer Bar Bushing

Removal NOTES: Some variation in the illustrations may occur, but the essential information is always correct. Removal steps in this procedure may contain installation details. 1. WARNING: Make sure to support the vehicle with axle stands. Raise and support the vehicle. 2. Remove the front wheels

© 2011-2024 Copyright www.rrevoque.org