Subaru Forester: Starting the engine
Do not operate the starter motor continuously for more than 10 seconds.
If the engine fails to start after operating the starter for 5 to 10 seconds, wait for 10 seconds or more before trying again.
NOTE
It may be difficult to start the engine
when the battery has been disconnected
and reconnected (for maintenance
or other purposes). This difficulty
is caused by the electronically
controlled throttle’s self-diagnosis
function. To overcome it, keep the
ignition switch in the “ON” position
for approximately 10 seconds before
starting the engine.
Preparing to drive
You should perform the following checks and adjustments every day before you start driving. 1. Check that all windows, mirrors, and lights are clean and unobstructed. 2. Check the appearance a ...MT models
1. Apply the parking brake. 2. Turn off unnecessary lights and accessories. 3. Press the clutch pedal to the floor and shift the shift lever into neutral. Hold the clutch pedal to the floor whil ...See also:
Adjusting the lumbar support
Vehicles without the memory function: You can adjust the contour of the front
seats so as to provide optimum support for your back.
Move adjustment lever 1 in the direction of the arrow until the ...
Compass
The vehicle may have a compass display on the Driver Information Center (DIC).
The compass receives its heading and other information from the Global Positioning
System (GPS) antenna, StabiliTrak, ...
Replacing lost transmitters
If you lose a transmitter or want to
purchase additional transmitters (up to
four can be programmed), you should reprogram
all of your transmitters for security
reasons. It is recommended that ...