Range Rover Evoque: Stalled adjustment

movement stops unexpectedly If seat movement stops unexpectedly during adjustment check for any obstructions and remove.

Once any obstructions have been removed the seat adjustment mechanism can be reset as follows.

Operate the button again to continue the stalled adjustment. When seat movement resumes hold the button until the end of travel in that direction has been reached. The seat position can now be carried out as normal.

Note: If no obstructions can be seen, but normal adjustment cannot be carried out without stalling, contact your Land Rover Dealer/Approved Repairer.

READ NEXT:

 Sitting in the correct position

The driver and front seat passenger must not ride with the seat fully reclined. Do not adjust the seat while the vehicle is moving. The seat, head restraint, seat belt and airbags, all con

 Memory seats

Front seat positions can be saved to vehicle memory. Once you have adjusted the power operated driver’s seat and the exterior mirrors, the vehicle can memorise the settings for future use. See

 Easy entry/exit

When Easy entry/exit is configured, the driver’s seat will automatically lower when the ignition is switched off and the door release lever is used. Upon returning to the vehicle, when the drive

SEE MORE:

 Opening and closing the bonnet

Opening and closing the bonnet Opening 1. Pull the bonnet release lever, located in the left-hand front footwell. 2. Lift the bonnet safety catch lever, located below the centre point of the bonnet, then raise the bonnet. Closing Do not drive with the bonnet retained by the safety catc

 Front Seat Backrest Heater Mat

Removal WARNINGS: To avoid accidental deployment and possible personal injury, the backup power supply must be depleted before repairing or replacing any air bag supplemental restraint system (SRS) components. To deplete the backup power supply energy, disconnect the battery ground cable and wait

© 2011-2024 Copyright www.rrevoque.org