Subaru Forester: Sounding a panic alarm
Sounding a panic alarm
A “PANIC” button is located on the back of the transmitter.
To activate the alarm, press the “PANIC” button once.
The horn will sound and the turn signal lights will flash.
To deactivate the panic alarm, press any button on the remote transmitter. Unless a button on the remote is pressed, the alarm will be deactivated after approximately 30 seconds.
Vehicle finder function
Use this function to find your vehicle
parked among many vehicles in a large
parking lot. Provided you are within 30 feet
(10 meters) of the vehicle, pressing the “”
button three times in ...
Selecting turn signal lights operation
When the remote keyless entry system is
used, the turn signal lights flash. However,
the turn signal lights flashing operational
non-operational setting can be changed.
Models with genuine SUBA ...
See also:
Mirrors
Inside Rearview
Mirror
Inside Rearview
Mirror
You can adjust the inside rearview mirror by hand so as to see the rear of your
vehicle in the mirror. To adjust the mirror, set the selector ta ...
Seat Heaters
If equipped
Both front seats are equipped with
seat heaters. The passenger seat
only has heaters in the seat bottom
because of the side airbag cutoff
system.
The ignition switch must ...
Low beam, Halogen
1. Remove the headlight housing from the
vehicle (see page 322).
2. Remove the cover over the bulbs (see
page 323).
3. Unplug the connector from the bulb.
4. Remove the bulb by pressing the h ...
