Range Rover Evoque manuals

Range Rover Evoque: Smart key check

Land Rover Range Rover Evoque L538 (2011–2018) Owner's Manual / Entering the vehicle / Smart key check

If the ignition is on or the engine is running and there is no Smart Key inside the vehicle when the last door is closed, the message Smart Key Not Found Refer to Handbook will be displayed in the message centre.

vehicle before it is driven to another Ensure that the Smart Key is in the vehicle before it is driven to another location. Without the Smart Key, if the ignition is turned off, it cannot be turned on again.

If only the ignition is on and the Smart Key is removed from the vehicle and the driver’s door is the last to be closed, the ignition will switch off.

Note: The engine cannot be started without the Smart Key in the vehicle.

READ NEXT:

 Disarming if the smart key and keyless entry fail to work

The vehicle can still be unlocked and the alarm disabled. To unlock the vehicle: 1. Unlock the left side front door using the key blade. The alarm will be triggered. 2. Position the Smart Key agai

 Deactivating the alarm when triggered

If the alarm has been triggered, it can be deactivated by any one of the following methods: - Pressing the unlock button on the Smart Key. - Opening a door using keyless entry. - Positioning a v

 Smart key system transmitters

Any person fitted with an implanted medical device should ensure that the device is kept at a distance of at least 22 cm (8.7 inches) away from any transmitter mounted in the vehicle. This is

SEE MORE:

 Oil Filter Housing

Removal NOTES: Some illustrations may show the engine removed for clarity. Some variation in the illustrations may occur, but the essential information is always correct. Removal steps in this procedure may contain installation details. 1. Refer to: Specifications (414-01 Battery, Mounting and Ca

 Rear Bumper Mounting

Removal NOTE: The rear bumper mounting is manufactured from mild steel. 1. In this procedure, to make sure the vehicle is correctly aligned, it must be placed on an approved alignment jig. 2. The rear bumper mounting is replaced in conjunction with: Rear bumper cover Rear bumper Back panel 3.

© 2011-2024 Copyright www.rrevoque.org