Range Rover Evoque: Safety in the garage
If the vehicle has been
driven
recently, do not touch exhaust and
cooling system components until the
engine has cooled.
Never leave the engine running in an
unventilated area - exhaust gases are
poisonous and extremely dangerous.
Never work or allow any person to
place any part of their body beneath a
vehicle supported by a jack.
Keep your hands and clothing away
from drive belts, pulleys and fans.
Some fans may continue to operate
after the engine has stopped.They
may also start to operate after the
engine is turned off and continue
operating for up to 10 minutes.
Remove metal wrist bands and
jewellery, before working in the
engine compartment.
Do not touch electrical leads or
components while the engine is
running, or with the starter switch
turned on.
Do not allow tools or metal parts of the
vehicle to make contact with the
battery leads or terminals.
READ NEXT:
Fuel system
Under no circumstances
should any
part of the fuel system be dismantled
or replaced by anyone other than a
suitably qualified vehicle technician.
Ensure sparks and naked lights are
kept away f
Service data recording
Service data recorders in your vehicle are
capable of collecting and storing diagnostic
information about your vehicle. This potentially
includes information about the performance or
status of var
Changing a bulb
If the lighting has just
been switched
off, give the bulbs time to cool.
Handling them when hot may cause
personal injury.
Always replace bulbs with
the correct
type and specification. If y
SEE MORE:
Seat belt (red)
Seat belt (red)
Illuminates when the ignition is on
and an occupied front seat belt is
unbuckled. The lamp will
extinguish after sixty seconds or when the
relevant seat belt(s) is buckled. In some
markets a warning chime will sound while the
lamp is illuminated.
Note: In some markets, the
Exhaust System
Exhaust System - GTDi 2.0L Petrol
Lubricants, Fluids, Sealers and Adhesives
* Apply to area around sensor threads prior to attempting to remove sensor
General Specification
Torque Specifications
** It is not appropriate to either fit or remove these fixings using air
tools due to a risk of cold
