Range Rover Evoque: Rolling re-start

If the engine is switched off while the vehicle is moving, a rolling re-start can be initiated.

Automatic transmission - select neutral (N) and then press the engine START/STOP button.

When the engine re-starts, select transmission position D.

Manual transmission - depress the clutch and then press the engine START/STOP button.

When the engine re-starts, select an appropriate forward gear.

READ NEXT:

 Keyless start backup

If the vehicle has been unlocked using the emergency key blade or the Smart Key is not detected by the vehicle, it will be necessary to use the keyless start backup to disarm the alarm and start t

 Stop/start (manual transmission only)

The Stop/Start system has been designed to improve fuel efficiency. The system is automatically activated when the ignition is switched on. When the engine has been stopped by the stop/start syst

 Conditions preventing automatic engine stop

The engine will not automatically stop if:<> - the external temperature is below approximately 0°C (32°F) - the external temperature is above approximately40°C (104°F) - engine has not re

SEE MORE:

 Playing a portable device

If you are using a USB mass storage device or approved iPod, you can control playback using the touch screen controls. If you are using a Bluetooth® device, you can control playback using the touch screen, but some controls are unavailable. If you are using any portable media device via the

 Anti-Lock Control - Traction Control FWD

Component Location NOTE: RHD (right-hand drive) installations shown; LHD (left-hand drive) installations similar. COMPONENT LOCATION - SHEET 1 OF 2 RH (right-hand) front wheel speed sensor RH rear wheel speed sensor LH (left-hand) rear wheel speed sensor LH front wheel speed sensor Integrate

© 2011-2024 Copyright www.rrevoque.org