Subaru Forester: Replacing bulbs
Bulbs may become very hot while illuminated. Before replacing bulbs, turn off the lights and wait until the bulbs cool down. Otherwise, there is a risk of sustaining a burn injury.
Replace any bulb only with a new bulb of the specified wattage. Using a bulb of different wattage could result in a fire. For the specified wattage of each bulb, refer to “Bulb chart”.
- Headlights (models with HID headlights)
- Headlights (models without HID headlights)
- Position light
- Front turn signal light
- Rear combination lights
- License plate light
- Dome light, map light, cargo area light and door step light
- Other bulbs
Installation of accessories
Always consult your SUBARU dealer before installing fog lights or any other electrical equipment in your vehicle. Such accessories may cause the electronic system to malfunction if they are in ...Headlights (models with HID headlights)
High-intensity-discharge (HID) bulbs are used for the low beams of the headlights. These HID bulbs use an extremely high voltage. To avoid the risk of an electric shock that could result ...See also:
Removing the cover to access the bulbs
NOTE
Before starting to replace a bulb, see
page 322.
1. Open the retaining clamps by pressing
them to the sides.
2. Pull the cover straight out.
Reinstall the cover in the reverse order. ...
Turning the System On and Off
The URPA system can be turned on and off using the infotainment system controls.
See Vehicle Personalization on page 5‑33 for more information.
When the system is off, PARK ASSIST OFF display ...
A/C – Air conditioner button
A/C – Air conditioner button
If the windshield starts to fog when the
climate control system is operated in the
AUTO mode, press the air conditioner
button “A/C” to defog and dehumidify ...