Nissan Rogue: Rear-facing child restraint installation using LATCH - Child restraints - Safety — Seats, seat belts and supplemental restraint 
system - Nissan Rogue Owner's ManualNissan Rogue: Rear-facing child restraint installation using LATCH

Refer to all Warnings and Cautions in the “Child safety” and “Child restraints” sections before installing a child restraint.

Follow these steps to install a rear-facing child restraint using the LATCH system:

1. Position the child restraint on the seat.

Always follow the child restraint manufacturer’s instructions.

Rear-facing web-mounted — step 2
Rear-facing web-mounted — step 2

2. Secure the child restraint anchor attachments to the LATCH lower anchors. Check to make sure the LATCH attachment is properly attached to the lower anchors.

Rear-facing rigid-mounted — step 2
Rear-facing rigid-mounted — step 2

Rear-facing — step 3
Rear-facing — step 3

3. For child restraints that are equipped with webbing-mounted attachments, remove any additional slack from the anchor attachments.

Press downward and rearward firmly in the center of the child restraint with your hand to compress the vehicle seat cushion and seatback while tightening the webbing of the anchor attachments.

Rear-facing — step 4
Rear-facing — step 4

4. After attaching the child restraint, test it before you place the child in it. Push it from side to side while holding the child restraint near the LATCH attachment path. The child restraint should not move more than 1 inch (25 mm), from side to side. Try to tug it forward and check to see if the LATCH attachment holds the restraint in place. If the restraint is not secure, tighten the LATCH attachment as necessary, or put the restraint in another seat and test it again. You may need to try a different child restraint or try installing by using the vehicle seat belt (if applicable). Not all child restraints fit in all types of vehicles.

5. Check to make sure the child restraint is properly secured prior to each use. If the child restraint is loose, repeat steps 1 through 4.

    Top tether anchor point locations
    Top tether anchor point locations Anchor points are located on the floor behind the outboard and center seating positions. The child restraint top tether strap must be used when installing chi ...

    Rear-facing child restraint installation using the seat belts
    The three-point seat belt with Automatic Locking Retractor (ALR) must be used when installing a child restraint. Failure to use the ALR mode will result in the child restraint not being p ...

    See also:

    Climate Control Sensors
    Sunlight and Temperature Sensors The climate control systemhas two sensors: a sunlight sensor on top of the dashboard, and a temperature and humidity sensor next to the steering column. D ...

    Connecting an iPod
    1. Open the upper glove box. 2. Push the release button to release the USB adapter cable. 3. Connect your dock connector to the iPod correctly and securely. 4. Install the dock connector ...

    Audio volume and automatic volume control
    The infotainment system compensates for disrupting noises in the passenger compartment by increasing the volume according to the speed of the vehicle. The level of sound compensation can be se ...