Subaru Forester: Programming for entrance gates and garage door openers in Canada
1. Unplug the motor of the entrance gate or garage door opener from the outlet.
NOTE
If any of the HomeLink® buttons are
already programmed for other devices,
skip step 2 because it clears the
memory of all three buttons.
1) HomeLink® button 1
2) HomeLink® button 2
3) HomeLink® button 3
2. Press and hold the two outer HomeLink® buttons (button 1 and button 3) until the HomeLink® indicator light begins to flash (after approximately 20 seconds). Then release both buttons.
3. Hold the end of the entrance gate’s/ garage door opener’s hand-held transmitter between 1 and 3 inches (25 and 76 mm) away from the HomeLink® button you wish to program.
4. Press and hold the desired HomeLink® button.
5. Press and release (“cycle”) the handheld transmitter button every 2 seconds until step 6 is complete.
6. When the indicator light flashes slowly and then rapidly after several seconds, release both buttons.
7. Plug the motor of the entrance gate/ garage door opener to the outlet.
8. Test your entrance gate/garage door opener by pressing the programmed HomeLink® button.
Programming rolling-code-protected garage door openers in the U.S.A.
If your garage door opener has a rolling
code feature, program the HomeLink®
Wireless Control System for it by following
steps 1 through 5 in “Garage door opener
programming in the U.S.A. ...
Operating the HomeLink® Wireless Control System
Once programmed, the HomeLink® Wireless
Control System can be used to
remote-control the devices to which its
buttons are programmed. To activate a
device, simply press the appropriate button ...
See also:
Trailer hitch
Choose a proper hitch for your vehicle and
trailer. A genuine NISSAN trailer hitch is
available from a NISSAN dealer. Make sure the
trailer hitch is securely attached to the vehicle to
help av ...
Cargo Cover
For vehicles with a cargo cover, use it to cover items in the rear of the vehicle.
To remove the cover from the vehicle, pull both ends toward each other. To reinstall,
place each end of the cover ...
Restricting the shift range
X Press the selector lever to the left towards D–.
The automatic transmission shifts down one gear and restricts the shift range
to the relevant gear.
If the engine exceeds the maximum engine ...
