Volvo XC60: Messages - Parking brake - Your driving environment - Volvo XC60 Owner's ManualVolvo XC60: Messages

Park brake not fully released – A fault is preventing

Park brake not fully released – A fault is preventing the parking brake from being released.

Try to apply the parking brake and release it several times. If the problem persists, contact an authorized Volvo workshop. If you drive off with this error message showing, a warning signal sounds.

Parking brake not applied – A fault is preventing the parking brake from being applied.

Try to apply the parking brake and release it several times. If the problem persists, contact an authorized Volvo workshop. If you drive off with this error message showing, a warning signal sounds.

Parking brake Service required – A fault has occurred. Try to apply and release. Contact a Volvo workshop if the fault remains.

WARNING
If the vehicle must be parked before the fault has been corrected, always put the gear selector in P and turn the wheels so that they point away from the curb if the vehicle is pointing uphill or toward the curb if it is pointing downhill.

    Symbols
    ...

    See also:

    Hazard warning flasher
    The Hazard Warning Flasher switch is located on the lower switch bank below the climate controls. Press the switch to turn on the Hazard Warning flasher. When the switch is activated, all direc ...

    Positioning a floor jack
    When raising your vehicle with a floor jack, position the jack correctly. Improper placement may damage your vehicle or cause injury. ■ Front ■ Rear CAUTION ■When raising yo ...

    In case a problem occurs
    If you cannot activate a device using the corresponding HomeLink® button after programming, contact HomeLink® at www.homelink.com or call 1-800-355- 3515 for assistance. ...