Subaru Forester: Manual transmission
Manual transmission
The manual transmission is a fully synchromeshed, 5-forward-speed and 1-reverse- speed transmission.
The shift pattern is shown on the shift lever knob. When shifting from 5th gear to reverse gear, first return the shift lever to the neutral position then shift into reverse gear.
To change gears, fully depress the clutch pedal, move the shift lever, and gradually let up on the clutch pedal.
If it is difficult to shift into gear, put the transmission in neutral, release the clutch pedal momentarily, and then try again.
- Do not drive the vehicle with the clutch disengaged (i.e., when the clutch pedal is depressed) or with the shift lever in the neutral position. Engine braking has no effect in either of these conditions and the risk of an accident is consequently increased.
- Do not engage the clutch (i.e., release the clutch pedal) suddenly when starting the vehicle.
By doing so the vehicle might unexpectedly accelerate or the transmission could malfunction.
Shift into reverse ONLY when the vehicle has completely stopped. It may cause damage to the transmission to try shifting into reverse when the vehicle is moving.
Changing the remote control batteries
- Do not let dust, oil or water get on
or in the remote engine start
transmitter when replacing the
battery.
- Be careful not to damage the
printed circuit board in the remote
engine st ...
Shifting speeds
...
See also:
Door locks
WARNING:
o Unlocked doors can be dangerous. Before
you drive away (especially if there
are children in the car), be sure that all the
doors are securely closed and locked so
that the doors c ...
Fuel pump shut off system
To minimize the risk of fuel leakage when the engine stalls or an airbag
inflates upon collision, the fuel pump shut off system stops supplying
fuel to the engine.
Follow the procedure below to res ...
Capacities and Specifications
Engine Specifications
...
