Range Rover Evoque: Interior lights locations

Interior lights locations
Interior lights locations

1. Sun visor lamps. Illuminates when the vanity mirror is opened.

2. Map reading lamps. Move a finger close to (or touch) the relevant lens to switch on/off.

Note: If you are wearing gloves, it may be necessary to touch the lens to operate the lamps.

3. Front interior lamp. Illuminates when the doors are unlocked and extinguishes 60 seconds after all doors are closed, when the engine starts or when the vehicle is locked. Move a finger close to (or touch) the lens to switch on and off manually.

Touch the lens for two seconds to deactivate/activate automatic illumination.

4. Glove box lamp. Illuminates when the glove box is opened.

5. Footwell lamps. Illuminates when the doors are unlocked and extinguishes 60 seconds after all doors are closed, when the engine starts or when the vehicle is locked.

6. Rear interior/reading lamps. Illuminates when the doors are unlocked and extinguishes 60 seconds after all doors are closed, when the engine starts or when the vehicle is locked. Press the switch to switch on and off manually. Touch the front courtesy lamp lens for approximately 2 seconds to deactivate/activate automatic illumination of the rear interior lamps.

7. Luggage compartment lamp. Illuminates when the tailgate is opened.

READ NEXT:

 Interior lights intensity

While the exterior lamps are turned on, intensity of interior lights can be adjusted. See 248, CONTROLS, Interior illumination control.

 Ambient lighting

The LED ambient lighting can be adjusted for colour and intensity via the touch screen. The exterior lamps must be turned on while changes are being made via the touch screen. See 104, TOUCH SCREE

 Wipers and washers

SEE MORE:

 Fuel Filler Door

Removal CAUTION: Make sure to protect the paintwork. 1. Installation 1. Fuel Filler Door Assembly Removal WARNING: Avoid flames, sparks or lighted substances. CAUTION: Extreme cleanliness must be exercised when handling these components. NOTES: Removal steps in this procedure may contain installa

 Inner Back Panel Assembly

Removal NOTES: The inner back panel assembly is manufactured from mild steel. The panel is serviced less its weld studs. The new service panel is not fully spot welded when supplied. It is necessary to remove a section of one rear lamp mounting panel to enable removal and installation of the inn

© 2011-2024 Copyright www.rrevoque.org