Mitsubishi Outlander: Ignition switch
[For vehicles equipped with the keyless operation system]
For information on operations for vehicles equipped with the keyless operation system, refer to “Keyless operation system: Ignition switch” on page 1-17.
[Except for vehicles equipped with the keyless operation system]
LOCK
The engine is stopped and the steering wheel locked. The key can only be inserted and removed in this position.
ACC
The engine is stopped, but the audio system and other electric devices can be operated.
ON
The engine is running, and all the vehicle’s electrical devices can be operated.
START
The starter motor operates. Once the engine starts, let go of the key. The key will automatically return to the “ON” position.
NOTE:
● This vehicle is equipped with ignition switch illumination. • The ignition switch
illumination comes on while the driver’s door is opened and remains on for about
30 seconds after the driver’s door is closed. • [Vehicles with the keyless entry
system] When you get out of the vehicle and remove the ignition key, it will be
illuminated for about 30 seconds. However, it will go off even while the illumination
comes on if the ignition switch is set to “ON” position.
● Your vehicle is equipped with an electronic immobiliser. To start the engine,
the ID code which the transponder inside the key sends must match the one registered
to the immobiliser computer. Refer to “Electronic immobiliser” on page 1-4.
To remove the key
Press the key in the “ACC” position. While pressing the key turn it to the “LOCK” position and then remove.
CAUTION:
● Do not remove the ignition key from the ignition switch while driving. The steering
wheel will be locked, causing loss of control.
● If the engine is stopped while driving, the brake servomechanism will cease to
function and braking efficiency will deteriorate. Also, the power steering system
will not function and it will require greater manual effort to operate the steering.
● Do not leave the key in the “ON” position for a long time when the engine is not
running, doing so will cause the battery to be discharged.
● Do not turn the key to the “START” position while the engine is running. Doing
so could damage the starter motor.
Outside rear-view mirrors
To adjust the mirror position The outside rear-view mirrors can be operated when the ignition switch is in the “ON” or “ACC” position. WARNING: ● Do not attempt to adjust the rear- ...Steering wheel lock
[For vehicles equipped with the keyless operation system]. For information on operations for vehicles equipped with the keyless operation system, refer to “Keyless operation system: Steering whe ...See also:
Bluetooth® Hands-Free Phone System (if so equipped)
- Use a phone after stopping your
vehicle in a safe location. If you
have to use a phone while driving,
exercise extreme caution at all
times so full attention may be given
to vehicle op ...
Towing
If your vehicle needs to be towed
If you need to tow your vehicle, we recommend that you contact a MITSUBISHI MOTORS
Authorised Service Point or tow truck company. In the following cases, transpo ...
Sky Slider™ Usage Precautions
NOTE:
• The system will not operate when ambient temperature
is at –4°F (–20°C) or lower.
• The system will not operate at vehicle speeds of
86 mph (138 km/h) or above.
• Opening a ...