Nissan Rogue: If your vehicle is stolen
If your vehicle is stolen, you should change the codes of any non-rolling code device that has been programmed into HomeLink®. Consult the Owner’s Manual of each device or call the manufacturer or dealer of those devices for additional information.
When your vehicle is recovered, you will need to reprogram the HomeLink® Universal Transceiver with your new transmitter information.
FCC Notice:
This device complies with FCC rules part 15. Operation is subject to the following two conditions: (1) This device may not cause harmful interference and (2) This device must accept any interference that may be received, including interference that may cause undesired operation.
The transmitter has been tested and complies with FCC and DOC/MDC rules.
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the device.
DOC: ISTC 1763K1313
FCC I.D.: CB2V67690
Reprogramming a single HomeLink® button
To reprogram a HomeLink® Universal Transceiver button, complete the following. 1. Push and hold the desired HomeLink® button. Do not release the button until step 4 has been completed. 2. Wh ...See also:
Emergency stop
If the seat accidentally begins to move, press
one of the buttons to stop the seat.
WARNING
• Because the driver's seat can be
adjusted with the ignition off, children
should never be left u ...
Setting station presets
1 Search for desired stations by turning
or pressing “∧”
or “∨” on .
2 Press and hold the button (from
) until you
hear a beep. ...