Subaru Forester: Headlight flasher
Headlight flasher
To flash the headlights, pull the lever toward you and then release it. The high beam will remain on for as long as you hold the lever. The headlight flasher works even though the light switch is in the “OFF” position.
When the headlights are on high beam,
the high beam indicator light “
” on
the
combination meter also illuminates.
Do not hold the lever in the flashing position for more than just a few seconds.
High/low beam change (dimmer)
High/low beam change (dimmer)
To change from low beam to high beam,
push the turn signal lever forward. When
the headlights are on high beam, the high
beam indicator light “” on the
c ...
Daytime running light system (if equipped)
The brightness of the illumination of
the high beam headlights is reduced
by the daytime running light system.
The light switch must always be
turned to the “” position
when it
is ...
See also:
Acc
In this position the electrical accessories
(radio, accessory power outlet, etc.) can
be used. ...
Severe climates
If you drive in extremely cold climates:
• It may be necessary to increase the coolant concentration
above 50%.
• NEVER increase the coolant concentration above 60%.
• A coolant concentratio ...
Intelligent Key system (if so equipped)
Intelligent Key system (if so equipped)
The Intelligent Key system can operate the
ignition switch without taking the key out from
your pocket or purse. The operating environment
and/or con ...
