Range Rover Evoque: Fuse box locations
Fuse box locations
When a fuse box lid is
removed, take
care to protect the box from moisture,
and refit the lid at the earliest
opportunity.
Engine compartment - fuse box access:
1. Remove the two plastic fixings.
2. Pull the tube up to release from the air box.
3. Delatch the tabs. The fuse box can now be
opened.
The engine compartment fuse numbers and
positions are shown on the inside of the fuse
box cover.
Passenger compartment - fuse box access.
There are two covers.
4. To access the upper part, open the
glovebox and remove the panel from the
glovebox liner. A label on the panel shows
the circuits protected and the fuse
locations.
5. To access the lower part, remove the lower
access panel.
Luggage compartment - fuse box access:
6. Remove the panel from the left side trim of
the luggage compartment.
READ NEXT:
Always turn off the ignition
system and
the affected electrical circuit, before
replacing a fuse.
Fit Land Rover approved replacement
fuses of the same rating and type, or
fuses of matching sp
SEE MORE:
CAUTION: If
the front airbags are deployed, the following components must be replaced:
Driver airbag module
Steering wheel
Passenger airbag module
Instrument panel
Fly leads (where applicable) connecting front airbag modules to SRS
harness
All seat belt buckle pre-tensioner
All occupied
CAUTION:
Diagnosis by substitution from a donor vehicle is NOT acceptable. Substitution
of control modules does
not guarantee confirmation of a fault, and may also cause additional faults in
the vehicle being tested and/or the donor
vehicle
NOTES:
If the control module or a component
© 2011-2024 Copyright www.rrevoque.org