Suzuki Grand Vitara: Fuel Gauge - Instrument Panel - Suzuki Grand Vitara Owner's ManualSuzuki Grand Vitara: Fuel Gauge

This gauge gives an approximate indication of the amount of fuel in the fuel
Fuel Gauge

This gauge gives an approximate indication of the amount of fuel in the fuel tank. “F” stands for full and “E” stands for empty. If the indicator gets off the graduation of “E” (not character “E”), refill the tank as soon as possible.

NOTE: The indicator moves a little depending on road conditions (for example, slope or curve) and driving conditions because of fuel moving in the tank.

If the low fuel warning light (1) comes on, fill the fuel tank immediately.

CAUTION: Avoid driving with an extremely low fuel level. Running out of fuel could cause the engine to misfire, damaging the catalytic converter.

NOTE: The activation point of the low fuel warning light (1) varies depending on road conditions (for example, slope or curve) and driving conditions because of fuel moving in the tank.

The mark (2) indicates that the fuel filler door is located on the right side of the vehicle.

    Tachometer
    Tachometer The tachometer indicates engine speed in revolutions per minute. CAUTION: Never drive with the engine speed indicator in the red zone or severe engine damage can result. ...

    Temperature Gauge
    Temperature Gauge When the ignition switch is in the “ON” position, this gauge indicates the engine coolant temperature. Under normal driving conditions, the indicator should stay within the ...

    See also:

    Location of Warning Messages
    Read and follow all of the warnings (labels etc.) on your vehicle. Make sure you understand all of them. Keep them on the vehicle. Do not remove the messages for any reason. If a label comes off o ...

    Programming rolling-code-protected garage door openers in the U.S.A.
    If your garage door opener has a rolling code feature, program the HomeLink® Wireless Control System for it by following steps 1 through 5 in “Garage door opener programming in the U.S.A. ...

    Changing
    WARNING Connect and disconnect the positive and negative cables in the correct sequence. ...