Range Rover Evoque: Fuel filler

all When refuelling ensure that all windows, doors, and sunroof are fully closed, particularly if young children or animals are in the vehicle.
Do not attempt to fill the tank to its maximum capacity. If the vehicle is to be parked on a slope, in direct sunlight, or high ambient temperature, expansion of the fuel could cause spillage.
Do not operate the auxiliary heater when refuelling the vehicle. Doing so may cause fuel vapours to combust causing a fire/explosion.

information Check the fuel pump information carefully, to ensure that you are putting the correct fuel into the vehicle.
If the vehicle is filled with incorrect fuel it is essential that you seek qualified assistance before you start the engine.

Filling station pumps are equipped with automatic cut-off sensing to avoid fuel spillage.

Fill the tank slowly until the filler nozzle automatically cuts-off the supply. Do not attempt to fill the tank beyond this point.

Note: Filling station pumps used for diesel commercial vehicles deliver fuel at a higher rate than normal. The higher fill rate can cause premature cut-off and may cause fuel spillage.
Therefore, it is recommended that only standard light vehicle pumps are used.

READ NEXT:

 Diesel misfuelling protection device

When the misfuelling device is activated, it may cause fuel to be discharged from the filler neck. Note: It is the driver’s responsibility to fill the vehicle with the correct fuel. The diesel

 Fuel tank capacity

Avoid the risk of running out of fuel and never intentionally drive the vehicle when the fuel gauge indicates that the tank is empty. When refuelling your vehicle after the fuel gauge reads empty,

 Fuel specification

Diesel vehicles in Algeria, Egypt, Libya, Morocco, India, Pakistan and Tunisia must only use premium diesel fuel.

SEE MORE:

 Drive Pinion Front Bearing

Special Tool(s) 100-012 Slide Hammer 205-067 Preload Gauge 308-615 Remover, Seals JLR-205-972 Mounting Bracket, Rear Axle JLR-205-984 Remover/Installer, Drive Pinion Nut JLR-205-985 Remover, Drive Pinion Bearing JLR-205-986 Installer, Drive Pinion Bearing Removal 1. Raise and support the vehicle. 2.

 Active On-Demand Coupling Module

Removal NOTE: If a new Active on-demand coupling module is installed, the throttle valve must also be installed. 1. WARNING: Make sure to support the vehicle with axle stands. Raise and support the vehicle. 2. 3. CAUTIONS: Make sure that the area around the component is clean and free of foreign m

© 2011-2024 Copyright www.rrevoque.org