Range Rover Evoque: Engine starting: manual transmission

Note: Do not press the accelerator pedal when starting the engine.

1. A valid Smart Key must be inside the vehicle.

2. Fully depress the clutch pedal.

3. Press and release the start button. For diesel engined vehicles there may be a delay while the glow plugs warm up, then the engine will crank automatically until it starts.

READ NEXT:

 If the engine fails to start

Note: If the engine fails to crank when the START/STOP button is pressed and there has been a recent collision, seek qualified assistance. If the engine fails to crank, or fails to start, consult

 Switching off the engine

Before switching off the engine, ensure that the vehicle is parked safely with the park brake applied. 1. Select P for automatic transmission, or neutral for manual transmissions. Note: If any ot

 Switching off the engine with the vehicle moving

It is not advisable to switch off the engine while the vehicle is moving. However, should such a situation arise, then the following procedure applies. - Press and hold the engine START/STOP

SEE MORE:

 Floor Console Upper Section

Removal NOTE: Removal steps in this procedure may contain installation details. All vehicles 1. CAUTION: The procedure must be carried out on both sides. NOTE: LH illustration shown, RH is similar. Torque: 1.9 Nm Vehicles with manual transmission 2. Refer to: Gearshift Lever Knob (308-06 Manual Tr

 Transmission Control Module (TCM)

 CAUTION: Diagnosis by substitution from a donor vehicle is NOT acceptable. Substitution of control modules does not guarantee confirmation of a fault, and may also cause additional faults in the vehicle being tested and/or the donor vehicle  NOTES: If the control module or a component

© 2011-2024 Copyright www.rrevoque.org