Suzuki Grand Vitara: Engine Hood
Engine Hood
To open the engine hood: 1) Pull the hood release handle located on the outboard side of the driver’s side of the instrument panel. This will disengage the engine hood lock halfway.
2) Push the under-hood release lever sideways with your finger, as shown in the illustration. While pushing the lever, lift up the engine hood.
3) Continue to lift up the hood until it is high enough to support with the prop rod.
To close the engine hood: 1) Lift the hood up slightly and remove the prop rod from the hole. Put the prop rod back to the holding clip. 2) Lower the hood close to the bumper, then let it drop down. Make sure the hood is securely latched after closing.
WARNING: Make sure the hood is fully closed and latched before driving. If it is not, it can fly up unexpectedly during driving, obstructing your view and resulting in an accident.
Sunroof (if equipped)
You can tilt or slide the sunroof by operating the “TILT” part of the sunroof switch or the “SLIDE” part of the sunroof switch when the ignition switch is in the “ON” position. There i ...Cup Holder and Storage Bin (if equipped)
Cup holders and a storage bin are provided as shown. To access a bin, push the release button. To use the console bin, pull the lever up and open the lid. To use the rear cup holders, open th ...See also:
Headlight Aiming
Since special procedures are required, we recommend you take your vehicle to
your SUZUKI dealer for headlight alignment. ...
Sunglasses Holder
To open the sunglasses holder, push
then release the raised detent. It will
unlatch and swing down. To close it,
push it until it latches. Make sure the
holder is closed while you are driv ...
Anti-trap protection
Closing a window or roof
blind onto
any part of the body can result in
serious injury.
Before closing a window or the roof
blind, ensure that no occupants have
any part of their body in a posi ...