Nissan Rogue: Control buttons
Control buttons
The control buttons for the Bluetooth® Hands- Free Phone System are located on the steering wheel.
PHONE SEND
Push the button to initiate a VR session or answer an incoming call.
You can also use the button to interrupt system feedback and give a command at once.
PHONE END
While the voice recognition system is active, push the button to go back one step. Push and hold the button for 5 seconds to quit the voice recognition system at any time.
Manual command selection
Commands can be selected manually. While the commands are displayed on the audio screen, select a command by operating the audio tuning switch, and then push the switch. Once a command is m ...Getting started
The following procedures will help you get started using the Bluetooth® Hands-Free Phone System with NISSAN Voice Recognition. For additional command options, refer to “List of voice comman ...See also:
Unfastening the seatbelt
Unfastening the seatbelt
Push the release button of the center
seatbelt buckle (on the left-hand side) to
unfasten the seatbelt.
NOTE
When the seatback is folded down for
greater cargo are ...
On-Pavement Driving
Government data show that most rollover accidents for multi-purpose vehicles
are caused when a driver loses control of the vehicle and leaves the paved portion
of the roadway striking a ditch, cur ...
Training procedure
1. Position the vehicle in a reasonably quiet
outdoor location.
2. Sit in the driver’s seat with the engine
running, the parking brake on, and the
transmission in Park.
3. Push and hold the ...