Ford Escape: Compass zone adjustment
1. Determine which magnetic zone
you are in for your geographic
location by referring to the zone
map.
2. Turn ignition to the on position.
3. Start the engine.
4. Press the SETUP control to select the Update Zone function and display the current ZONE XX in the center stack display.
5. Continue to press the RESET control until the correct zone appears in the center stack display.
6. The direction will display after the RESET control is released. The zone is now updated.
Electronic compass (if equipped)
The compass heading is displayed in the center stack display. The compass reading may be affected when you drive near large buildings, bridges, power lines and powerful broadcast antenna. Magnetic ...Compass calibration adjustment
Perform compass calibration in an open area free from steel structures and high voltage lines. For optimum calibration, turn off all electrical accessories (heater/air conditioning, wipers, etc.) an ...See also:
Important information
The information contained in this handbook covers all vehicle derivatives and
optional equipment,
some of which may not be fitted to your vehicle. Due to printing cycles, this
handbook may includ ...
Replacing light bulbs
■ Headlights
Right side only: Remove the clip
and move it aside to allow easy
access to the light bulbs.
Turn the bulb base counterclockwise.
1 Headlight (low beam)
2 Headlight (high b ...
TTY Users
OnStar has the ability to communicate to the deaf, hard&-ofhearing, or speech&-impaired
customers while in the vehicle. The available dealer&-installed TTY system can provide
in-vehicl ...