Mercedes-Benz GLK-Class: Cleaning the paintwork - Exterior care - Care - Maintenance and care - Mercedes-Benz GLK-Class Owner's ManualMercedes-Benz GLK-Class: Cleaning the paintwork

Scratches, corrosive deposits, areas affected by corrosion and damage caused by inadequate care cannot always be completely repaired. In such cases, visit a qualified specialist workshop, e.g. an authorized Mercedes-Benz Center.

  • Remove impurities immediately, where possible, whilst avoiding rubbing too hard.
  • Soak insect remains with insect remover and rinse off the treated areas afterwards.
  • Soak bird droppings with water and rinse off the treated areas afterwards.
  • Remove coolant, brake fluid, tree resin, oils, fuels and greases by rubbing gently with a cloth soaked in petroleum ether or lighter fluid.
  • Use tar remover to remove tar stains.
  • Use silicone remover to remove wax.

Do not affix:

  • stickers
  • films
  • magnetic plates or similar items to painted surfaces. You could otherwise damage the paintwork.

If water no longer forms "beads" on the paint surface, use the paint care products recommended and approved by Mercedes- Benz. This is the case approximately every three to five months, depending on the climate conditions and the care product used.

If dirt has penetrated the paint surface or the paint has become dull, the paint cleaner recommended and approved by Mercedes- Benz should be used.

Do not use these care products in the sun or on the hood while the hood is hot.

  • Use a suitable touch-up stick, e.g. MB Touch-Up Stick, to correct smaller areas of paint damage quickly and provisionally.
    Cleaning the wheels
    Do not use acidic wheel cleaning products to remove brake dust. This could damage wheel bolts and brake components. Do not park the vehicle for an extended period straight after cleaning it, ...

    Matte finish care
    If your vehicle has a clear matte finish, observe the following instructions in order to avoid damage to the paintwork due to incorrect care. These notes also apply to light alloy wheels with a cle ...

    See also:

    Operation
    If the driver and/or front passenger have/ has not yet fastened the seatbelt(s) when the ignition switch is turned to the “ON” position, the seatbelt warning light(s) will flash for 6 seco ...

    Weight specifications
    The gross trailer weight is calculated by adding the weight of the trailer to the weight of the load and equipment on the trailer. Permissible gross weight: 3500 lbs (1588 kg). The permissible Tra ...

    Unlocking the rear gate
    Unlocking the rear gate Pressing the “” button unlocks the rear gate. An electronic chirp will sound twice and the turn signal lights will flash twice. ...