Subaru Forester: Channel scan - Channel and category selection - Satellite radio operation (if equipped) - Audio - Subaru Forester Owner's ManualSubaru Forester: Channel scan

Press the “SCAN” button briefly (type A, B

Press the “SCAN” button briefly (type A, B and C audio)/for more than 1.5 seconds (type D audio) to change the radio to the SCAN mode. In this mode, under the selected category, the radio scans through the channel until a station is found. The radio will stop at the station for 5 seconds while displaying the channel number, after which scanning will continue until the entire channel has been scanned from the low end to the high end.

Press the “SCAN” button briefly (type A, B and C audio)/for more than 1.5 seconds (type D audio) again to cancel the SCAN mode and to stop on any displayed channel.

    Type D audio
    When in the SAT mode, press the button to change the category search mode. When in the category search mode, press the following button to change the category up or down. When a category ...

    See also:

    Turning the System On and Off
    The URPA system can be turned on and off using the infotainment system controls. See Vehicle Personalization on page 5‑33 for more information. When the system is off, PARK ASSIST OFF display ...

    Important ventilating information
    If the engine is idling while the vehicle is stopped for a long period of time, open the windows at least 1 inch (2.5 cm) or adjust the heating or air conditioning to bring in fresh air. ...

    Folding down the rear seat backrests
    The three sections of the rear seat backrest can be folded down in different combinations to make it easier to transport long objects. • The left (driver's side) section can be folded down se ...