Subaru Forester: Bulb chart
Lights A and B are the LED (Light Emitting Diode) type. Consult your SUBARU dealer for replacement.
- Bulbs may become very hot while illuminated. Before replacing bulbs, turn off the lights and wait until the bulbs cool down. Otherwise, there is a risk of sustaining a burn injury.
- For models with HID low beam headlights, observe the following precautions. Not doing so carries the risk of an electric shock that could result in serious injury because the HID bulbs use an extremely high voltage.
– Do not replace any headlight bulbs (both low beam and high beam) by yourself.
– Do not remove/restore the headlight assemblies by yourself.
– Do not remove any headlightassembly components by yourself.
For replacement, contact your SUBARU dealer.
Replace any bulb only with a new bulb of the specified wattage. Using a bulb of different wattage could result in a fire.
Fuse panel located in the engine compartment
A) Main fuse ...Vehicle identification
Vehicle identification 1) Vehicle identification number 2) Emission control label 3) Tire inflation pressure label 4) Certification label 5) Vehicle identification number plate 6) Model n ...See also:
Information display
Information display
1) Outside temperature indicator
2) Fuel consumption indicator
With the ignition switch in the “ON”
position, the outside temperature and fuel
consumption are indic ...
Low beam light bulbs
Right-hand side
1. Use a screwdriver to undo the clips on
the air intake duct, then remove the air
intake duct (right-hand side).
Left-hand side
2. Use a screwdriver to remove the
secured ...
When the VSC/TRAC are operating
If the vehicle is in danger of slipping
or if any of the drive wheels
spins, the slip indicator light
flashes to indicate that the VSC/
TRAC systems are operating.
A buzzer (intermittent) sound ...