GMC Terrain: Auxiliary Taillamp
To replace one of these lamps:
1. Open the liftgate. See Liftgate on page 2‑9.
2. Remove the interior trim access panel.
A. Attachment Nuts
B. Retaining Hook
3. Remove the five attachment nuts (A) securing the taillamp assembly to the
liftgate.
4. Disengage the retaining hook (B) and pull the taillamp assembly out of the vehicle
liftgate.
5. Disconnect the lamp wiring harness.
6. Turn the bulb socket counterclockwise and pull it out.
7. Pull the bulb straight out of the socket.
8. Install the new bulb.
9. Push the bulb socket in and turn it clockwise.
10. Reverse Steps 2 through 5 to reinstall lamp assembly.
Stop/Tail/Turn Signal/ Sidemarker Lamp
To replace one of these lamps: 1. Open the liftgate. See Liftgate on page 2‑9. 2. Remove the two screw covers from the taillamp assembly. 3. Remove the two screws securing the taillamp asse ...Back–Up Lamp
Removal of the lamp assembly is not required to replace the back-up lamp bulb. To replace one of these lamps: 1. Open the liftgate. See Liftgate on page 2‑9. 2. Remove the interior trim acces ...See also:
Engine
...
Standby mode (temporary deactivation)
Press to temporarily deactivate
cruise control
(put it in standby mode). The set speed, for
example 55 mph, is then shown in parentheses.
The previously set speed and time interval are
resum ...
Changing/disconnecting a device
- From the menu, select Change device.
- Select Disconnect. A confirmation pop-up
will appear and then you will be given the
option to Search new or select a different
device from the list of pair ...