Hyundai Tucson: Insrtument cluster
FUEL GAUGE
The needle on the gauge indicates the approximate fuel level in the fuel tank. The fuel capacity is given in Section 9.
ENGINE COOLANT TEMPERATURE GAUGE
WARNING: Never remove the radiator cap when the engine is hot. The engine coolant is under pressure and could erupt and cause severe burns. Wait until the engine is cool before adding coolant to the reservoir.
The needle on the engine coolant temperature gauge should stay in the normal range. If it moves across the dial to "H" (HOT), pull over and stop as soon as possible and turn off the engine. Then open the hood and, after the engine has cooled, check the coolant level and the water pump drive belt. If you suspect cooling system trouble, have your cooling system checked by a Hyundai dealer as soon as possible.
TACHOMETER
The tachometer registers the speed of your engine in revolutions per minute (rpm).
CAUTION: The engine should not be raced to such a speed that the needle enters the red zone on the tachometer face. This can cause severe engine damage and may void your warranty.
SPEEDOMETER
Your Hyundai's speedometer is calibrated in miles per hour (on the outer scale) and kilometers per hour (on the inner scale).
ODOMETER/TRIP ODOMETER
Odometer (1)
The odometer records the total driving distance in kilometers or miles, and is useful for keeping a record for maintenance intervals.
NOTE: Any alteration of the odometer may void your warranty coverage.
Trip odometer (2)
o This mode indicates the drive distance travelled since the last drive time reset. o You can choose the TRIP A or TRIP B by pressing the trip odometer switch for less than 1 second.
Warning and Indicator lights
SRS (Airbag) Service
Reminder Indicator (SRI)
The SRS service reminder indicator (SRI) comes
on for about 6 seconds after the ignition key is
turned to the "ON" position or after th ...
Trip computer
(If installed)
The trip computer is a microcomputer-controlled
driver information gauge that displays
information related to driving, such as a tripmeter,
distance to empty, average fuel cons ...
See also:
Ventilation
To operate the ventilation system:
o Set the air intake control to "Fresh" mode
().
o To direct all intake air to the dashboard
vents, set the airflow control to "Face" ( ...
Parking brake stroke
Check the parking brake stroke according
to the maintenance schedule in the
“Warranty and Maintenance Booklet”.
When the parking brake is properly
adjusted, braking power is fully applied ...
Blind spot monitor
The Blind
Spot Monitor (BSM) system
is a supplement to, not a replacement
for, a safe driving style and use of the
exterior and rear-view mirrors.
Please note that BSM may not be able
to give ...