Mitsubishi Outlander: Indicator lamps
Turn-signal indicator lamps/Hazard warning indicator lamps
These indicator lamps blink on and off when a turn-signal lamp is operating.
NOTE:
● If the blinking is too fast, the cause may be a blown lamp bulb or a faulty turn-signal
connection. When the hazard warning lamp switch is pressed, all turn-signal lamps
will flash on and off continuously.
High-beam indicator lamp
This indicator lamp illuminates when the high beam is used.
Front fog lamp indicator lamp *
This lamp illuminates while the front fog lamps are on.
Rear fog lamp indicator lamp
This lamp illuminates while the rear fog lamps are on.
Position lamp indicator lamp
This lamp illuminates with the lamp switch at or position.
Diesel preheat indicator lamp
This indicator lamp illuminates when the ignition switch is placed in the “ON” position. As the glow plug becomes hot, the lamp goes out and the engine can be started.
NOTE:
● If the engine is cold, the diesel preheat indicator lamp is on for a longer time.
● When the engine has not been started within about 5 seconds after the diesel preheat
indicator lamp went out, return the ignition switch to the “LOCK” position. Then,
turn the switch to the “ON” position to preheat the engine again.
● When the engine is warm, the diesel preheat indicator lamp does not come on even
if the ignition switch is placed in the “ON” position.
Indicator lamp, warning lamp, and information screen display list
Indicator and warning lamp list 1- Turn-signal indicator lamps/Hazard warning indicator lamps → P. 3-50. 2- High-beam indicator lamp → P. 3-50. 3- Diesel preheat indicator lamp → ...Warning lamps
Brake warning lamp This lamp will illuminate for a few seconds when the ignition switch is turned to the “ON” position. A warning is also displayed on the multi-information display. With the ...See also:
Top Tether
WARNING
Always lock the rear seat backrests in their upright position when the rear seats
are occupied by passengers. Lock the rear seat backrests in their upright position
before installing ...
Air Conditioning
A/C (Air Conditioning): Press to turn the air conditioning on or off. If the
fan is turned off or the outside temperature falls below freezing, the air conditioning
will not work. When in AUTO, th ...
Replacing bulbs
Bulbs may become very hot while
illuminated. Before replacing bulbs,
turn off the lights and wait until the
bulbs cool down. Otherwise, there is
a risk of sustaining a burn injury.
Re ...