Nissan Rogue: If the windows do not close automatically
If the power window automatic function (closing only) does not operate properly, perform the following procedure to initialize the power window system.
1. Turn the ignition switch to the ON position.
2. Close the door.
3. Open the window completely by operating the power window switch.
4. Pull the power window switch and hold it to close the window, and then hold the switch more than 3 seconds after the window is closed completely.
5. Release the power window switch. Operate the window by the automatic function to confirm the initialization is complete.
If the power window automatic function does not operate properly after performing the procedure above, have your vehicle checked by a NISSAN dealer.
Auto-reverse function (if so equipped)
There are some small distances immediately
before the closed position which
cannot be detected. Make sure that all
passengers have their hands, etc., inside
the vehicle before closing the ...
Moonroof (if so equipped)
- In an accident you could be thrown
from the vehicle through an open
moonroof. Always use seat belts
and child restraints.
- Do not allow anyone to stand up or
extend any portion of thei ...
See also:
To use as full-automatic climate control system
1. Place the temperature control dial in
the position for the preferred temperature.
2. Set the airflow control dial and fan
speed control dial in the “AUTO” position.
The system’s functio ...
Seat fabric
Remove loose dirt, dust or debris with a
vacuum cleaner. If the dirt is caked on the
fabric or hard to remove with a vacuum
cleaner, use a soft brush then vacuum it.
Wipe the fabric surface wit ...
Opening and closing the hood
1 Pull the lever located under the left side of
the dash to release the hood lock. An information
symbol will illuminate when the
hood is open.
2 Lift the hood slightly. Press the release
c ...
