GMC Terrain: When the System Does Not Seem to Work Properly
The following messages may be displayed on the DIC:
SERVICE PARKING ASSIST: If this message occurs, take the vehicle to your dealer to repair the system.
PARK ASSIST OFF: If the URPA system does not activate due to a temporary condition, the message displays on the DIC. This can occur under the following conditions:
○ The driver has disabled the system.
○ The ultrasonic sensors are not clean. Keep the vehicle's rear bumper free of mud,
dirt, snow, ice, and slush. For cleaning instructions, see Exterior Care on page
10‑83.
○ The park assist sensors are covered by frost or ice. Frost or ice can form around
and behind the sensors and may not always be seen; this can occur after washing
the vehicle in cold weather. The message may not clear until the frost or ice has
melted.
○ A trailer was attached to the vehicle, or an object was hanging out of the liftgate
during the last drive cycle. Once the object is removed, URPA will return to normal
operation. . A tow bar is attached to the vehicle.
○ The bumper is damaged. Take the vehicle to your dealer to repair the system.
○ Other conditions, such as vibrations from a jackhammer or the compression of air
brakes on a very large truck, are affecting system performance.
Turning the System On and Off
The URPA system can be turned on and off using the infotainment system controls. See Vehicle Personalization on page 5‑33 for more information. When the system is off, PARK ASSIST OFF display ...Rear Vision Camera (RVC)
The vehicle may have a Rear Vision Camera (RVC) system. Read this entire section before using it. The RVC can assist the driver when backing up by displaying a view of the area behind the vehicle ...See also:
Parking
To park the vehicle, fully engage the parking brake, and then move the gearshift
lever to 1st or “R” (Reverse) position.
Parking on a hill
To prevent the vehicle from rolling, follow these pro ...
Rear-view mirror (manual anti-glare)
X anti-glare mode: flick anti-glare switch 1 forwards or back. ...
Changing gear
The automatic transmission shifts to the individual gears automatically when
it is in transmission position D. This automatic gearshifting behavior is determined
by:
a shift range restriction, ...