Range Rover Evoque: Voice
- Command list: View the categories and the acceptable voice commands.
Select an Information button to view alternative function commands.
- Voicetags: View the categories. Select a category to manage the voicetags for the chosen system. See 140, VOICETAGS.
- Operating guide: View brief Voice system instructions. Select Voice tutorial for more detailed instructions (cancel via the displayed pop-up or by pressing and holding the voice button).
- Preferences: Select to alter the following
settings:
- Voice profile: The voice system can be
trained to have a greater recognition of
a particular voice or accent.The default
setting is Standard. To build a voice
profile for either User 1 or 2, it is
necessary to complete a training
program first.
To complete the training for the first
time, select either User 1 or User 2 and
follow the on-screen and audible
instructions.
- Voice feedback: Select On or Off.
- Feedback volume: Adjust using the +/-
buttons. It is not possible to reduce the
volume to zero.
- Voice training: Select to access the voice system training program, designed to enable the system to better recognise the vocal characteristics of a user.
Select User 1 or User 2 and follow the on screen and audible instructions. See 140, VOICE TRAINING.
The training session can be cancelled at any time by touching the on-screen pop-up or by pressing and holding the Voice button on the steering wheel. See 139, OPERATION.
READ NEXT:
Valet
Selection:
Valet mode allows the vehicle to be driven and
locked by a parking attendant, without giving
access to the luggage compartment. Valet
mode also prevents operation of the touch
screen,
Extra features
There are more features available than can be
displayed at one time. This menu allows the
selected features to be displayed, for example:
- Ambient lighting: While the headlamps are
turned on, sel
Touch screen care
Do not use abrasive cleaners
on the
touch screen. For approved cleaning
products, contact your Dealer/
Authorised Repairer.
The touch screen and inner bezel must be kept
clean to maintain opti
SEE MORE:
Rear Side Member Section
Removal
NOTES:
The rear side member section is manufactured from RP260, with its inner
reinforcement manufactured from DP600.
The rear side member section is cut from the rear side member service panel, the
section also includes the upper and lower side
extensions.
1. In this procedure, to make s
Fuel Rail
Special Tool(s)
310-198
Installer, Teflon Seal
310-199
Re-shape Tool, Teflon Seal
Removal
CAUTION: Make sure that all openings are sealed. Use new blanking caps.
NOTE: Some variation in the illustrations may occur, but the essential
information is always correct.
1. Disconnect the battery ground c
