Subaru Forester: Valet mode
When you choose the valet mode, the alarm system does not operate. In valet mode, the remote transmitter is used only for locking and unlocking the doors and rear gate and panic activation.
To enter the valet mode, change the setting of your vehicle’s alarm system for deactivation mode. Refer to “Activating and deactivating the alarm system”. The security indicator light will continue to flash once every 3 seconds indicating that the system is in the valet mode.
To exit valet mode, change the setting of your vehicle’s alarm system for activation mode. Refer to “Activating and deactivating the alarm system”.
Disarming the system
Briefly press the “”
button (for less than
2 seconds) on the remote transmitter. The
driver’s door will unlock, an electronic
chirp will sound twice, the turn signal
lights will flash ...
Passive arming
When passive arming mode has been
programmed by the dealer, arming of the
system is automatically accomplished
without using the remote transmitter. Note
that in this mode, DOORS MUST BE
MAN ...
See also:
Warning
WARNING: You should take extreme
care when working on your vehicle to prevent accidental injury. Here are a few precautions
that you should be especially careful to observe:
• To prevent da ...
Change intervals
The oil and oil filter change intervals for your
engine are based on the use of the specified
quality oils and filters. Using an engine oil and
filter other than the specified quality, or exceed ...
Warranties
The warranties covering your vehicle are explained in a separate New Vehicle
Warranty Information booklet given to you at the time of sale. Please read this
booklet carefully so you can understand ...
