GMC Terrain: Turn and Lane-Change Signals
An arrow on the instrument panel cluster will flash in the direction of the turn or lane change.
Move the lever all the way up or down to signal a turn.
Raise or lower the lever until the arrow starts to flash to signal a lane change. Hold it there until the lane change is complete. If the lever is briefly pressed and released, the turn signal flashes three times.
The lever returns to its starting position when it is released.
If after signaling a turn or a lane change the arrows flash rapidly or do not come on, a signal bulb may be burned out.
Have the bulbs replaced. If the bulb is not burned out, check the fuse; see Fuses on page 10‑38 for more information.
Hazard Warning Flashers
(Hazard Warning Flasher): Press
this button, on the center of the instrument panel, to make the front and rear turn
signal lamps flash on and off. This warns others that you are having trouble. ...
Fog Lamps
The fog lamps control is located on the turn/lane change lever.
Use the fog lamps for better vision in foggy or misty conditions.
FOG (Fog Lamps): Turn the fog lamp
band on the lever to and re ...
See also:
Activating/deactivating
WARNING
Any accumulation of snow and ice should be removed from the rear window before
driving. Visibility could otherwise be impaired, endangering you and others.
The rear window defroster h ...
Setting a speed
Once ACC has been put in standby mode, use
the or
buttons to store (set) the vehicle's
current speed. This puts the system in active
mode. The set speed, for example 55 mph, is
shown in th ...
Cleaning the plastic trim
WARNING
When cleaning the steering wheel boss and dashboard, do not use cockpit sprays
or cleaning agents containing solvents. Cleaning agents containing solvents cause
the surface to become ...
