Jeep Liberty: Transfer Case Position Indicator Lights
The four-wheel drive indicator lights (4WD and 4 LOW) are located in the instrument cluster. The NEUTRAL indicator light is located on the transfer case switch. If there is no indicator light on or flashing, the transfer case position is two-wheel drive (2WD). If the indicator light is on, the desired position (4WD LOCK, 4WD LOW, or NEUTRAL) has been obtained.
If One Or More Shift Requirements Are Not Met:
• An indicator light will flash.
• The transfer case will not shift.
NOTE: The “SERV 4WD Warning Light” monitors the electric shift four-wheel drive system. If this light remains on after engine start up, or it illuminates during driving, it means that the four-wheel drive system is not functioning properly and that service is required.
Shift Positions
The transfer case switch is located on the center console
next to the shift lever.
Transfer Case Switch
2WD
Rear Wheel Drive High Range - This range is used for
normal street and highway driv ...
Shifting Procedures
NOTE: If any of the requirements to select a new
transfer case position have not been met, the transfer case
will not shift, the indicator light for the previous position
will remain on, and the ...
See also:
Important safety notes
The HomeLink® garage door opener integrated in the rear-view mirror allows you
to operate up to three different door and gate systems.
Certain garage door drives are incompatible with the integ ...
Fuel information
Your vehicle must use only unleaded gasoline.
Select octane rating 87 (Research Octane Number 91) or higher. Use
of unleaded gasoline with an octane rating lower than 87 may result
in engine knocki ...
Changing the voice tag of the cell phone
1. Select the “CHANGE NAME” menu. If
no cell phones are registered, “EMPTY” is
displayed and the mode changes to the
“PHONE SETUP” mode.
2. Select the cell phone by operating the
...
