Subaru Forester: To set cruise control
1. Push the “CRUISE” main switch button.
Type A
Type B
The cruise control indicator light on the combination meter will illuminate.
2. Depress the accelerator pedal until the vehicle reaches the desired speed.
3. Push the “SET/COAST” button and release it. Then release the accelerator pedal.
Type A
Type B
At this time, the cruise control set indicator light on the combination meter will illuminate.
The vehicle will maintain the desired speed.
Vehicle speed can be temporarily increased while driving with the cruise control activated. Simply depress the accelerator pedal to accelerate the vehicle.
When the accelerator pedal is released, the vehicle will return to and maintain the previous cruising speed.
Cruise control
Cruise control enables you to maintain a
constant vehicle speed without holding
your foot on the accelerator pedal and it is
operative when the vehicle speed is 25
mph (40 km/h) or more. Make ...
To temporarily cancel the cruise control
The cruise control can be temporarily
canceled in the following ways.
- Push the “CANCEL” button.
- Depress the brake pedal.
- Depress the clutch pedal (MT models
only).
- Shift the se ...
See also:
Warning light—driver braking required
Adaptive Cruise Control can exert brake force
that is equivalent to approximately 40% of the
vehicle's total braking capacity. In situations
requiring more brake force than ACC can provide
and ...
Entry gate programming
The technology of some entry gates requires
you to press and re-press (cycle) the hand-held
transmitter button every two seconds during
programming.
Continue to press and hold the desired
HomeLin ...
Brakes
If the brakes do not operate properly, have the
brakes checked by a NISSAN dealer. ...
